Hook Type Inslot Winding MachineHIM-03 Applicable core : Inside slot stator
Model HIM-03 has been developed for inside slot stators winding with new technology `Hook Winding` which uses outward fingers to slide wires through stator slots instead of nozzles passing in the slot.
The `hook` finger tool with NC control also enables precision winding.
 |
|---|
| HIM-03 |
Features
- No nozzle space is required in the slots. It enhances slot-fill up to 70%.(ref.)Maximum Slot-fill Insert Winding 85% Hook Winding 70% Nozzle Winding 50%
- This is concentrated direct winding. Therefore, lower end turns can be achieved, and the motor itself can be smaller.
- With forming tool, multi-wire winding is enabled at tight slot opening.
- Multiple wires can be wound at once, including heavy gages, since the nozzle does not enter the slot.
| Model | HIM-03 |
|---|---|
| Applicable core size | Outer dia. : ø75mm- ø130mm Inner dia. : ø40mm- ø85mm Stack height : 20mm-80mm |
| Available wire gauge | Single wire Max. : ø1.6mm Multi. wire Max. : ø0.55mmx16 wires |
| Single wire Max. | 3 sec./1T (Depends on coil spec.) |
| Nozzle oscillations angle | Programmable to any angle (Single purpose by hook profile) |
| Up/down stroke | Programmable to any angle (Up/down hook position adjusting) |
| Core indexing | Programmable to any angle |
| Winding width | Hook position by NC |
| No. of control axes | 9 axes by AC servomotor |
| Power supply | AC200V ±10% 3-phase 50/60Hz |
| Air supply | Min. 0.5MPa |
| Machine dimensions | 1,400(W)x1,200(D)x2,420(H)mm |
| Machine weight | Approx. 1,800kg |
